Draw with one, switch to a new one. If you look closely at the pin you drew with and that rubber stop is a hard one..... Ouch !! doll pin and a chance to get some of that rubber stopper in your pin. No thanks I'll use a new pin every time.
Just grab some extra pins ? You can buy just pins.
bros! Even after one time of going through a stopper when you look at the needle with a very high powered lens you can see it will already be starting to bend and warp.
Every time you pin you're building up scar tissue as well, you want that pin as sharp as possible. Even if you pin in different places, eventually you will be able to tell... its just a little harder to push the pin through that scar tissue. Especially after years of AAS use. I definitely concur with all these guys,... NEW pin Every Time!
Dr gave me 18g to draw and 25g to pin. After 1st pin, leg was sore so looked it up and found some info with large ga. pins and stopper (info same as above). The read recommended warm vial and draw with smaller ga.pin less chance of stopper damage. Put heating pad in microwave bout 1 1/2 mins. wrap vial, jump in shower, draw with 23g no prob. change to 25g and shoot. 2nd pin was in my ass and my eyes don't work as good, I thought pin was stuck, had to put my glasses on, but it was in/gone and no pain. Next 2 pins the same. I will be warming gear from here on out. My 2 cents.
I do agree. I run my loaded fun under hit water for like 30 seconds and it pushes much easier.
Draw with 20's pin with 23x1",1-1/2"
I used to do the same but anything over a 1 inch needle seems to give me more pip. And I do still use 23ga for water based suspensions.
i pinned same spot, once with 27ga 1.5 in and once with 25ga 1 inch. The 25ga gave me much less pip, even repeated this a few times with same results.